R5RENT / Sprzęt / Hydraulic toe jack 10 tons
Hydraulic toe jack 10 tons
1 / 3
Hydraulic toe jack 10 tons 1
Hydraulic toe jack 10 tons 2
Hydraulic toe jack 10 tons 3
WYNAJEM

Hydraulic toe jack 10 tons

Hydraulic toe jack with maximum static load of 10 tons. Head capacity 7.5t, toe capacity 6t. Working range 35–320 mm, stroke 160 mm. Screw adjustment 0–80 mm. Weight 25 kg.

49
netto / dobę + kaucja 400
Zarezerwuj ten sprzęt501 401 550
DOCUMENTATION
Operating manual

Head and toe load ratings, matching the jack to the lifting point, raising and lowering the load, cribbing, maintenance and troubleshooting. Read online or download as PDF (document in Polish).

Wersja 1.0 | 2026-08-30
Open manual →

Dane techniczne

Max static load10 000 kg
Head capacity7 500 kg
Toe capacity6 000 kg
Min height (toe/head)35 / 320 mm
Lift stroke160 mm
Screw adjustment0–80 mm
Weight25 kg

FAQ

What will a 10-ton toe jack actually lift?

The "10 tons" in the name is the static load rating, not the lifting capacity — and the distinction matters when you size the job. On the head it lifts 7,500 kg; on the toe, 6,000 kg. The toe rating is lower because it works on an overhang and carries a bending moment rather than a clean axial load. On top of that, a toe jack almost always works in a pair or a set of four and never lifts the whole machine at once, only one corner — so what counts is the load on that corner, not the total mass. Not sure how the mass is distributed? Call us and we will help you estimate it.

Should I lift on the toe or on the head?

Use the toe when you need to get in low — under a frame, a skid or the base of a machine standing almost flat on the floor. The minimum toe height is 35 mm, so it fits where nothing else will. Use the head when there is already clearance underneath (head height 320 mm) or when you are lifting through a timber block — you get a higher capacity and a more stable support. Rule of thumb: lift on the toe only far enough to slide in a block or introduce the skates, never to hold the machine there.

Note: the load table in the manufacturer’s documentation

In the Polish documentation supplied with these jacks, the "Head" and "Toe" labels in the load table are sometimes swapped. The binding reference is the drawing on the same page — it shows the correct distribution — together with the values we publish in the technical data: head 7,500 kg, toe 6,000 kg. We verified this independently: the HP10 is structurally the MTJ06 from the MTJ series, with identical weight, heights and stroke. We state it openly because taking the table at face value leads to an incorrect — and unsafe — equipment choice.

Do you deliver this equipment on site?

Yes. A 10-tonne hydraulic claw jack — we deliver it across the Silesian agglomeration: Katowice, Gliwice, Zabrze, Bytom, Ruda Śląska, Chorzów, Sosnowiec, Dąbrowa Górnicza, Tychy, Mysłowice, Siemianowice Śląskie, Świętochłowice, Piekary Śląskie, Czeladź, Będzin, Mikołów, Knurów, Jaworzno, Tarnowskie Góry, Łaziska Górne, Bieruń and Lędziny. We bring the equipment to your address and collect it after the rental — a flat 200 PLN net round trip (delivery + pickup). Outside the agglomeration we quote transport individually — just give us a call.

📞 Call now📅 Request a quote